束变换环孔激光谐振腔的环束场传输差分计算

 通过使用新的坐标变量和光场的表达形式，推导了新坐标系下环束场传输的偏微分方程，给出了相应差分方程的截断误差和稳定性条件，使得环束场传输计算速度大幅提高；使用二阶精度的Crank-Nicolso差分方法对束变换环孔激光谐振腔的环束场传输进行了计算，并与W.D.Murphy和M.L.Bernabe所给M-B积分近似方法的计算结果进行了比较，证实了该方法无论计算速度和精度都优于M-B积分近似方法。     

腔长失调对光腔衰荡法测量精度的影响

 只考虑腔长失调因素下建立了反射率模拟测量的理论模型。根据高斯光束传输规律分析了腔长失调对衰荡腔模式耦合的影响，推导了腔长失调与谐振腔输出脉冲信号、衰荡信号与反射率之间的关系，模拟了腔长失调在±10mm范围内的光脉冲衰荡现象。结果表明：对于光敏面直径为0.2mm的高速探测器，为了保证10^-6的测量精度，腔长的失调量应控制在±1mm之间。在光路调节中采用具有对数变换功能的示波器和动态范围较大的探测器，可以提高测量精度。     

回旋速调管放大器输出腔的特性研究

 利用变截面波导的耦合模理论，根据输出腔中电场幅值分布函数所满足的微分方程组，编写了具有自动优化功能的计算程序，分析研究了不同渐变角度、考虑腔体损耗前后和输出腔与外电路失配时，谐振频率、腔体品质因数和高频场幅值沿轴分布的变化情况，为进一步研究高频场与电子注的互作用和输出腔奠定了基础。     

Lattice Boltzmann simulation of two-sided lid-driven flow in a staggered cavity

In this article, the lattice Boltzmann method is employed in order to explore incompressible fluid flow inside a two-sided lid-driven staggered cavity. Results of the lattice Boltzmann simulation for antiparallel motion of lids are compared with the data from existing literature. For parallel motion of lids, the characteristics of flow pattern for a variety of Re numbers (50–3200) are presented. An asymmetric steady-state flow pattern for parallel motion of lids is obtained.     

On the limitation of the van der Waals-Platteeuw-based thermodynamic models for hydrates with multiple occupancy of cavities

Thermodynamic models based on the van der Waals–Platteeuw statistical theory (Adv. Chem. Phys. 2, 1 (1959)) can be very accurate in describing hydrate equilibrium conditions, even for some occasions when multiple cavity occupancy occurs. These are cases outside the range of assumptions used for the development of the original statistical theory. However, during multiple cavity occupancy such models can perform poorly when calculating the cavity occupancies. This paper reports novel Grand Canonical Monte Carlo molecular simulations for the case of pure structure II N₂ hydrate and compares the calculated cavity occupancies with experimental data and observe reasonable agreement. Also examined are the van der Waals–Platteeuw-based modifications that retained the single-occupancy assumption of the original theory and how they perform when predicting cavity occupancies and hydrate equilibrium pressures.     

Ideal optomechanically induced transparency generation in a cavity optoelectromechanical system

The ideal optomechanically induced transparency effects of an output probe field are investigated in a cavity optoelectromechanical system, which is composed of an optical cavity, a charged mechanical resonator, and a charged object.Although the charged mechanical resonator damping rate is nonzero, the ideal optomechanically induced transparency can still appear due to the non-rotating wave approximation effect in the system. The location of optomechanically induced transparency dip can be controlled via the Coulomb coupling strength. In addition, we find that both the transparency window width and the maximum dispersion curve slope are closely related to the optical cavity decay rate.     

1.3 GHz超导腔磁通排出效应研究

设计并搭建了一套高精度的磁场测量和补偿系统,并结合中国科学院高能物理研究所(IHEP)的2K超导腔垂直测试平台对1.3 GHz单加速间隙超导腔的磁通排出效应开展了实验研究:利用研制的磁场测量和补偿系统能够精密地测量超导腔赤道位置磁场,并能够将磁场补偿至小于5.0×10-8 T;并对超导腔不同表面温度梯度下的磁通排出效应进行了测量分析;对钉扎了磁场的超导腔进行了射频性能测试,研究了超导腔电阻对磁通钉扎的敏感度,以及在不同电场梯度下超导腔的表面电阻变化情况。结果表明,研制的高精度磁场测量和补偿系统能够满足超导腔磁通排出研究的需求;高的超导腔表面温度梯度有利于磁通的排出;磁通钉扎电阻的敏感度随着加速电场梯度的增加而增大,导致超导腔的性能下降。此实验研究也为后续超导腔的研制奠定了一定基础。     

An evaluation method for measuring SPL and mode shape of tire cavity resonance by using multi-microphone system

This paper presents an evaluation method for measuring the sound pressure level and mode shapes of tire cavity resonance by using a multi-microphone system. Two commercial tires were evaluated to compare abilities of noise suppression by means of this method in the range of the first resonance from 200 to 260 Hz. One tire was a special tire that suppresses tire cavity resonance with polyurethane foam mounted on the tire’s inner liner. The other tire was a normal tire with no polyurethane foam. The mode shape change from vertical to horizontal direction in both tires. However, the sound pressure level of the special tire was lower than the normal tire at all frequencies.     

Reinvestigation of the ν2 + 2ν3 subband in the overtone icosad of 12CH4 using cavity ring-down (CRD) spectroscopy of a supersonic jet expansion

We report a detailed reinvestigation of the ν₂?+?2ν₃ combination band of methane ¹²CH₄ centred at (7510.3378?±?0.003)?cm^?1 ((225.154263?±?0.0001)?THz) within the icosad of the overtone absorption. A new experimental setup is described, allowing us to carry out cw-laser cavity ring-down spectroscopy (cw-CRDS) at instrumental resolution in the MHz range in seeded supersonic jet expansions down to rotational temperature of 7?K compared to previous cw-CRDS measurements in our group achieving about 50?K in expansions of neat CH₄. We provide a careful re-analysis on the basis of our new experimental results for the Q and R branch transitions including data obtained between about 7 and 300?K under various conditions. We resolve previously observed discrepancies of assignments and are able to present a definitive assignment for lines involving angular momentum quantum numbers up to J?=?4. The analysis of relative intensities in spectra taken at rotational and effective translational temperatures between about 50?K and less than 10?K indicate conservation of nuclear spin symmetry upon supersonic jet expansion, in agreement with previous results using other techniques and covering other spectral ranges.     

In vitro monitoring of goat-blood glycemia with a microwave biosensor

We used an electromagnetic microwave cavity sensor for real time measurement of the glycemia in goat-blood for three animals. We could determine the concentration of d-glucose in blood in the range of 90–550 mg/dl at the resonance frequency near 4.76 GHz with a bandwidth of 300 MHz. The change in microwave reflection coefficient S₁₁ (due to the variation of d-glucose concentration in blood) was about 16.33 dB, 23.92 dB, 7.66 dB and resonance frequency shift was about 21.78 MHz, 36.29 MHz, 20.77 MHz, respectively, for the three different samples. The in vitro results show the measured signal-to-noise ratio of about 32 dB, and the minimum detectable signal level of about 0.025 dB/(mg/dl). The results clearly show the sensitivity and usefulness of this microwave sensor for these types of biological investigations. This proposed system provides a unique approach for real contactless glucose monitoring and, it may serve as a bloodless glucometer for the calibration of different glucose levels.